# Parquet Finish: Gloss, Satin or Matte in Madrid

> Visual guide to choosing between gloss, satin, matte or ultra-matte finishes on parquet. Light reflection, how visible footprints are and real samples in Madrid.

URL: https://www.parksinta.com/en/blog/parquet-finish-gloss-satin-matte/  

---

- [![Parquet roble poliuretano disolvente brillo scaled scaled](https://www.parksinta.com/wp-content/uploads/2016/02/Parquet-roble-poliuretano-disolvente-brillo-scaled-scaled.jpg.webp?v=20260602imgfix)](https://www.parksinta.com/wp-content/uploads/2016/02/Parquet-roble-poliuretano-disolvente-brillo-scaled-scaled.jpg.webp?v=20260602imgfix)

Satin is the mid-sheen finish: it reflects some light without glare and shows footprints less than gloss. When a wood floor is sanded you have to choose between gloss, satin, matte or ultra-matte. That choice changes the light in the room and how much the marks of use show.

**In short:** gloss reflects a lot of light and shows footprints and scratches more. Satin usually works well in a home with daily use. Matte hides marks better and gives a more natural look. The sheen level does not change the resistance: the Bona and Deva data sheets give a single wear figure for all the sheens of each finish.

## What the finish does: protecting the pores and shaping the light

Sanding leaves the wood clean and flat, and the finish protects it from wear. The sheen of the finish then decides how the floor looks: how much light it gives back and how much dust and footprints show.

An old solvent-based finish yellows over the years and turns oak orange. Waterborne polyurethane usually makes the floor lighter than old finishes, and you can decide how much without going as far as staining. The differences between the two are in [waterborne versus solvent-based finish](https://www.parksinta.com/en/blog/waterborne-polyurethane-finish-vs-traditional-varnish/).

![Parquet de roble con barniz brillo al disolvente, de tono anaranjado](https://www.parksinta.com/wp-content/uploads/2016/02/Parquet-roble-poliuretano-disolvente-brillo-scaled-scaled.jpg.webp?v=20260602imgfix)

*Source: ParkSinta technical archive. Oak with a gloss solvent-based finish: orange tone and a mirror-like reflection.*

![Parquet de roble con barniz brillo al agua, de tono más claro](https://www.parksinta.com/wp-content/uploads/2016/02/Parquet-roble-poliuretano-al-agua-brillo-scaled-1200x900.jpg.webp?v=20260602imgfix)

*Source: ParkSinta technical archive. Oak with a gloss waterborne finish: it reflects just as much and the tone is lighter.*

## Sheen scale: what UNE-EN ISO 2813 measures and what the data sheets give

The UNE-EN ISO 2813 standard describes how to measure the specular gloss of a finish: light is projected at an angle of 20°, 60° or 85° and the amount reflected back is measured. The standard does not say what satin or matte is: each finish manufacturer sets its own levels.

There is no common scale. The [Bona Traffic HD data sheet](https://www.parksinta.com/wp-content/uploads/2016/01/Ficha-tecnica-de-producto-Bona-Traffic-HD-040215_es.pdf) gives, measured at 60°, a gloss of about 40 for satin, 20 for matte and 11 for extra matte. The [Aquadeva Transit Plus data sheet](https://quideva.com/wp-content/uploads/2023/02/Aquadeva-Transit-Plus.-rev15.pdf) gives about 90 for gloss, 57.5 for satin, 27.5 for matte and 12.5 for super matte. It does not state the angle.

Bona’s satin falls between Deva’s satin and matte. That is why, when choosing, what counts is the specific product and not just the word “satin” or “matte.”

## Choosing according to the light in the home

Gloss makes dust, footprints and small scratches more visible, above all when light from a window comes in at a low angle across the floor. It makes sense in classic interiors or when a lot of reflection is wanted, but it is the finish that suffers most from daily use.

In a home with a lot of light, a matte or ultra-matte finish removes reflections and lets the wood read more naturally. In a house with less natural light, a soft satin gives back a little more light without glare.

![Parquet de tablilla en espiga con barniz brillo que refleja la ventana](https://www.parksinta.com/wp-content/uploads/2025/09/acabado_brillo_w1920_q72-1200x900.webp)

*Source: ParkSinta technical archive. Gloss on a herringbone parquet: the floor reflects the window like a mirror.*

![Suelo de marquetería con barniz satinado junto a una ventana](https://www.parksinta.com/wp-content/uploads/2019/07/Marqueteria-Bona-Traffic-HD-Satinado-scaled.jpg.webp)

*Source: ParkSinta technical archive. Satin (Bona Traffic HD) on marquetry: it reflects the light from the window without becoming a mirror.*

![Salón con suelo de marquetería y barniz mate](https://www.parksinta.com/wp-content/uploads/2019/07/Bona-Traffic-HD-Mate.jpg.webp)

*Source: ParkSinta technical archive. Matte (Bona Traffic HD) in a living room with marquetry: the window is barely reflected.*

## Ultra-matte finishes and the raw wood look

To make the wood look unfinished we apply Deva Transit Plus Natur and Bona Traffic HD Raw, on oak and other woods. They form a film like any finish, but they barely reflect light.

On old pitch pine, as on other woods, ultra-matte changes the tone quite a lot; with the other finishes the change is softer. Unlike oil, an ultra-matte finish is not fed or waxed. According to the Bona data sheet, over the years it is renewed with a new coat of finish, without sanding down to the wood.

![Tarima de pino melis viejo con acabado ultramate](https://www.parksinta.com/wp-content/uploads/2019/07/Pino-melis-viejo-Bona-Naturale-UltraMate-scaled.jpg.webp)

*Source: ParkSinta technical archive. Old pitch pine with an ultra-matte finish: there is hardly any reflection and the whole grain shows.*

![Suelo de cuadros de nogal y pino melis con acabado ultramate](https://www.parksinta.com/wp-content/uploads/2019/07/Nogal-y-Melis-Bona-Naturale-ULtraMate-scaled.jpg.webp)

*Source: ParkSinta technical archive. Walnut and pitch pine in ultra-matte: against the light, next to the windows, some reflection can be seen.*

## Comparison table of sheen levels and maintenance

The decision should not be made from a photo alone. The same finish changes with the wood, the light in the room and the tone left after sanding, and both data sheets recommend a test first. That is why we recommend seeing real samples on the actual wood whenever the project allows it.

| Finish | Bona Traffic HD (gloss at 60°) | Aquadeva Transit Plus (gloss) | How it looks | Footprints and marks |
| --- | --- | --- | --- | --- |
| Gloss | No gloss version on the data sheet | ≈ 90 | Reflects light like a mirror | Dust, footprints and scratches show more |
| Satin | ≈ 40 | 57,5 ± 2,5 | Reflects some light without becoming a mirror | Middle ground |
| Matte | ≈ 20 | 27,5 ± 2,5 | Soft, diffuse reflection | Hides marks better |
| Extra matte or super matte | ≈ 11 | 12,5 ± 2,5 | Almost no reflection | Hides marks better |

### Frequently asked questions

**Is a matte finish harder to clean, or does it hold more stains?**

No. Matte is achieved with matting agents, mainly silica, which scatter light at the surface of the finish. It is cleaned like any other: a dust mop and, for wet cleaning, a well-wrung mop with the parquet cleaner the finish data sheet specifies.

**Is a satin finish more slippery than matte when walking barefoot?**

It depends on the specific finish more than on the name of the sheen, and the figure comes from each product’s test. In a home, the Código Técnico de la Edificación (Spanish Building Code) does not require a slip-resistance class for the floor. For uses such as retail or public assembly it does require one, and then that test is requested.

**Can the sheen of the floor be changed without having to sand the wood?**

Yes, if the existing finish is waterborne and sound: without sanding, the surface is buffed and deep-cleaned and a new coat is applied in the sheen you want. Over urea-formaldehyde or solvent-based polyurethane finishes we do not recoat, and then the floor has to be sanded. We explain it in [recoating parquet or wood flooring](https://www.parksinta.com/en/blog/recoating-parquet-without-sanding/).

**What is an ultra-matte finish and when is it a good choice?**

It is a very low-sheen finish that leaves the wood looking freshly sanded. It suits natural or Nordic styles and places where you want to avoid reflections and footprints. For natural and ultra-matte finishes we apply Deva Transit Plus Natur and Bona Traffic HD Raw, on oak and other woods.

**How do you lighten reddish woods (jatoba, merbau) without them changing color?**

They are lightened in three steps, from less to more: an ultra-matte or natural finish, a one-coat stain and, with two coats, a full whitewash effect. Before staining, the red is isolated with a sealer coat. We do not do chemical bleaching: “lightening” means changing the tone with lighter finishes or stains. The stain we use is Bona Craft Oil, which goes on as the first coat with the finish on top. The result depends on the species, and before deciding we test it on the actual wood. The Deva data sheet also calls for that test on oily exotic woods such as merbau. The three steps are explained in [Lightening an old parquet floor](https://www.parksinta.com/en/blog/lighten-old-parquet-floor/).

**What is the difference between staining and finishing?**

Staining gives the wood color; finishing seals and protects it, and the two are usually combined: stain for the color and a finish on top. We stain only with Bona Craft Oil, and we keep alcohol-based or water-based stains for spot repairs. Each species responds differently: the tone is chosen from a range and tested on the specific wood before starting.

Choosing and applying wood finishes in Madrid

The finish is best chosen by looking at the wood, the light in the home and the real condition of the floor. A photo gives a guide, but it does not replace seeing it on site. A similar case: [Solid oak restoration with a natural finish – Húmera (Pozuelo)](https://www.parksinta.com/en/projects/engineered-oak-natural-finish-restoration-humera-pozuelo/).

[Parquet Finishes](https://www.parksinta.com/en/wood-floor-finishes-madrid/)
 [📞 +34 91 543 90 62](tel:+34915439062)
 [Book an appointment in Chamberí (Donoso Cortés 24)](https://www.parksinta.com/en/contact/)
